HMK® S34
Silicone Impregnator

APPLICATION:
A silicone base impregnator of highest stability against dirt, water, oil, and alkali infiltration. For interior and exterior use on all natural and cast stone and regardless of surface finish. Surface treated with HMK® S34 is 98% vapor permeable, UV resistant, and leaves a natural appearance. Not effective on non-absorbing surfaces.

DIRECTIONS:
Apply to chemically clean and dry surface with a roller, a natural bristle brush or the HMK® Z170-171 brushes. One or two even applications, wet on wet are usually sufficient. For more absorbent surfaces additional coats may be required. Allow 5-10 minutes between each application for penetration. Thoroughly remove excess HMK® S34 5-10 minutes after last application with a terry cloth towel by adding more S34 or pure solvent if necessary to facilitate the removal of S34. Allow to cure for at least 24 hours.

COVERAGE:
100 - 200 sqft., 9-18 square meters on polished surfaces, 50-100 sqft., 4.5-9 square meters on other surfaces per 1 liter (34 oz.) container.

WARNING:
Chemical product. Contains Turpentine Substitute. Flammable. Use with adequate ventilation. Avoid eye and skin contact. If exposed, wash/flush with water. Keep out of reach of children. See Material Safety Data Sheet.

PACKAGING:
1/4 liter cans (8.5 oz.) 25 per case, 1 liter cans (34 oz.) 12 per case, 5 liter cans (5.68 qts.) 4 per case, 10 liter cans (11.36 qts.) 2 per case.

STORAGE:
Store in a cool place. Keep lid tightly closed.

TESTING:
Perform testing on a sample tile and actual installation to determine number of coats necessary to protect particular stone, visual appearance of tile after S34 application and stain protection against water, dirt, and oil infiltration.

DISCLAIMER:
Limitation of liability: The liability of HMK® for defective products and any claims for damages whatsoever is limited to the purchase price of the products. HMK® shall not be liable for any consequential damages. No other warranty or representation is made or implied.